Replacing Hood Struts Tesla Model X

If your hood struts start to break for whatever reason, they can be replaced. To repair your hood struts, follow these steps:

• To support the hood, open it and prop it up using a non-marring prop.
• Remove the underhood apron in the rear centre.
• Remove the underhood aprons on the LH and RH sides.
• Release the clip on the bottom of the strut with a trim tool and pull the strut away from the attachment on the vehicle's body.
• Release the clip on the top of the strut using a trim tool and take the strut away from the hood mount. The old strut should be removed from the car.
• Clean the mounting places on the car, then lubricate the replacement strut's two pivot points.
• Secure the strut's rod end to the vehicle's body, then the strut's body end to the hood. Make sure the clips are in place.
• Remove the hood prop and double-check that the hood opens and closes properly.
• Install the underhood aprons on the LH and RH sides.
• Install the underhood apron in the back centre.

Disclaimer:
Tesla, Inc. was not involved in the development of this document and did not provide any input or otherwise edit, review or authorize it.